GameBoy Advance taustavalon modauskitti

Uusi ja laadukas modauskitti (engl. high light modification kit) tee-se-itse ihmiselle, joka haluaa GameBoy Advance (GBA) käsikonsoliinsa upean kirkkaasti taustavalaistun LCD näytön. Asentaminen ei vaadi kotelon leikkaamista.

Valmistajan tarkempi tuote-esittely ja asennusohje (katso myös kuvat):

"NOTE:

The installation tutorial is below, please install it strictly according to the following tutorial. The wire on the flex cable must be connected to the positive side of the battery holder for the LCD screen to power on.

1. IPS LCD screen. No need for chipping welding. Easy installation.
2. Distribute 32-pin and 40-pin flat cables, which can be used no matter what version you are. GBASP can also be supported by purchasing GBASP cables.
3. The normal AA battery lasts about 10 hours, and the power consumption of different game cards will vary. Support low battery prompt.
4. Support point-to-point display. Display in black and white.
5. Support shutdown brightness memory and display style memory

Each set of LCD screens has been tested before shipment. It is best not to install it before installation. Power on and test it first to avoid subsequent installation errors that may cause the LCD screen to fail to operate normally.

Don't squeeze the LCD screen. Don't wipe the LCD screen with a wet towel. Squeezing the LCD frame and back cover will lead to uneven backlight display, light spot and dark spot.

Installation introduction

1. GBA motherboard cable is divided into 32 pins and 40 pins, choose the cable you use. There is a cable label under the cable holder.
2. Put the double-sided adhesive tape and the LCD screen limit block first. The LCD screen limit blocks are placed on the bottom two sides of the casing.
3. Then install the LCD screen and the LCD screen adapter board. The LCD screen should be as close to the far right as possible,and the top of the frame should be just at the position of the two small bumps.
4. The wire on the cable must be connected to the positive LCD screen of the battery holder to turn on! Just wrap the wire around the battery holder. Do not touch the exposed wire and wire with other components, it will short circuit!"

HUOM!

- Tarkasta yhteensopivuus ennen tilaamista (sopii kaikkiin normaaleihin Nintendo GameBoy Advance käsikonsoleihin)
- Tuotteen mukana ei tule asennus- tai käyttöohjetta
- Asentaminen vaatii taitoa ja ymmärrystä käsikonsolin tekniikasta
- Emme ota vastuuta tuotteen vahingoittumisesta, joka johtuu virheellisestä asennuksesta tai väärästä tuotemallista